Produse pentru transmit plasticul (4)

PIU is excited about original ideas and welcomes the opportunity to work closely with our clients in developing new products. We offer a uniquely collaborative approach focused on translating your idea into a production-ready injection molding product.

PVC Lumps

Syntech StopAQ Mono-component Sealant compound, permanently plastic, slightly warm (+10% in volume in contact with water), for waterproofing underground holes, through which one or many wires and/or technical pipes pass, in masonry structures. It is extruded around the cables passing using specific dosing gun for 600 ml bags, and then covered with thixotropic mortar Repar Tix G2. - It does not harden over time, while maintaining its original plasticity. - It is a non-toxic material. - It is easy to apply, it adheres both to dry and wet surfaces. Usable even in the presence of slight water seepage. - It expands slightly in contact with water (+10% ), thereby sealing any losses that may arise due to subsidence or vibration. Waterproof sealing for drilled holes in walls of concrete, bricks, tufa, etc., which are crossed by passing electrical cables and/or technical tubes in general (gas, plumbing, etc.). Dust, soil, sand, loose parts, rust, and layers of paint of the pipes and old deteriorated sealant material must be removed with pressurised water or brushing, before applying the compound. The inner surface of the tube/hole containing the passing cables should be damp or wet. To limit the thickness of Syntech StopAQ, it is recommended to insert a barrier of polyethylene foam kerbs with an appropriate diameter (Filtene Fondogiunto). Syntech StopAQ will be extruded into the hole to be sealed, taking care that the paste encompasses all the passing cables. Compact, with the help of a wooden handle or the like, the paste just extruded against the polyethylene "barrier" previously positioned to seal all the gaps. The depth of clogging made with Syntech StopAQ must be at least 8-10 cm. Smooth the outer surface of Syntech StopAQ, with special spatula or gloved hand, compacting it well. Finally, close the "mouth" outside of the tube/hole with Repar Tix G2, minimum 2 cm thick, smoothing around the cables with a spatula. Approximately 1.7 cartridges of Syntech StopAQ for each cubic decimetre of volume to be filled. Cartridge 533 cc

PLANTIC™ wird für die Herstellung von Lebensmittelverpackungen mit Barriere verwendet und reduziert durch vielfältige Möglichkeiten der Optimierung des Verpackungsaufbaus schädliche Umwelteinflüsse. PLANTIC™ selbst besteht bis zu 80% aus erneuerbaren Rohstoffen und wird hauptsächlich in Trays und Vakuum-Skin-Verpackungen mit hoher Barriere eingesetzt. Dies ermöglicht die direkte Verbesserung der Umweltbilanz der Lebensmittelverpackung. PLANTIC™ enthält keine Weichmacher, es konkurriert nicht mit der Produktion von Lebensmitteln und verwendet ausschließlich Rohstoffe, die nicht gentechnisch verändert sind.